Response Surface Approach to Optical Channel Dropping Filter Design Parameters Optimization

Authors

  • H. Hazura Centre for Telecommunications Research Innovations (CETRI), Faculty of Electronic & Computer Engineering, Universiti Teknikal Malaysia Melaka, 76100 Durian Tunggal, Melaka.
  • F. Aliman Centre for Telecommunications Research Innovations (CETRI), Faculty of Electronic & Computer Engineering, Universiti Teknikal Malaysia Melaka, 76100 Durian Tunggal, Melaka.
  • A.S.M. Zain Centre for Telecommunications Research Innovations (CETRI), Faculty of Electronic & Computer Engineering, Universiti Teknikal Malaysia Melaka, 76100 Durian Tunggal, Melaka.
  • A.R Hanim Centre for Telecommunications Research Innovations (CETRI), Faculty of Electronic & Computer Engineering, Universiti Teknikal Malaysia Melaka, 76100 Durian Tunggal, Melaka.
  • F. Salehuddin Centre for Telecommunications Research Innovations (CETRI), Faculty of Electronic & Computer Engineering, Universiti Teknikal Malaysia Melaka, 76100 Durian Tunggal, Melaka.
  • S.K Idris Centre for Telecommunications Research Innovations (CETRI), Faculty of Electronic & Computer Engineering, Universiti Teknikal Malaysia Melaka, 76100 Durian Tunggal, Melaka.
  • M.Z Nor Syaimaa Centre for Telecommunications Research Innovations (CETRI), Faculty of Electronic & Computer Engineering, Universiti Teknikal Malaysia Melaka, 76100 Durian Tunggal, Melaka.

Keywords:

Response Surface Methodology, Optical Channel Dropping Filter, Microring Resonator,

Abstract

The objective of this paper is to optimise the design parameters for the optical channel dropping filter, which is based on the microring resonator topology. The most important parameters to determine the performance of the microring channel optical filter are the waveguide width, gap, core thickness and ring radius. The determination of parameters by classical experimental design methods requires a large amount of experimental data, which has been found to be costly and time-consuming. To overcome this drawback, a design of experiment (DOE) methods of the Response Surface Methodology (RSM) was employed. This paper employed the RSM design analysis in evaluating the performance of the microring resonator with different design parameters settings. Upon completion, the RSM shows that the optimum condition can be achieved when the ring radius is 5.50μm, a gap of 200nm, waveguide width of 418 nm and core thickness of 220 nm. In conclusion, for optimized performance of the channel dropping filter, design conditions within the range demonstrated in this study are suggested.

Downloads

Download data is not yet available.

Downloads

Published

2018-07-04

How to Cite

Hazura, H., Aliman, F., Zain, A., Hanim, A., Salehuddin, F., Idris, S., & Nor Syaimaa, M. (2018). Response Surface Approach to Optical Channel Dropping Filter Design Parameters Optimization. Journal of Telecommunication, Electronic and Computer Engineering (JTEC), 10(2-5), 125–129. Retrieved from https://jtec.utem.edu.my/jtec/article/view/4397

Most read articles by the same author(s)

1 2 3 > >>