Dual Band Planar Microwave Sensor for Dielectric Characterization using Solid and Liquid Sample

Authors

  • Norhanani Abd Rahman Centre for Telecommunication Research & Innovation, Faculty of Electronics and Computer Engineering, Universiti Teknikal Malaysia Melaka (UTeM), 76100 Durian Tunggal, Melaka, Malaysia. Department of Electrical Engineering, Polytechnics Seberang Perai (PSP), Pulau Pinang, Malaysia.
  • Zahriladha Zakaria Centre for Telecommunication Research & Innovation, Faculty of Electronics and Computer Engineering, Universiti Teknikal Malaysia Melaka (UTeM), 76100 Durian Tunggal, Melaka, Malaysia.
  • Rosemizi Abd Rahim School of Computer and Communication Engineering, University Malaysia Perlis (UniMAP), Perlis, Malaysia.
  • Yosza Dasril Centre for Telecommunication Research & Innovation, Faculty of Electronics and Computer Engineering, Universiti Teknikal Malaysia Melaka (UTeM), 76100 Durian Tunggal, Melaka, Malaysia.
  • Amyrul Azuan Mohd Bahar Centre for Telecommunication Research & Innovation, Faculty of Electronics and Computer Engineering, Universiti Teknikal Malaysia Melaka (UTeM), 76100 Durian Tunggal, Melaka, Malaysia.

Keywords:

Dual Mode, DMS, DGS, Q-factor, Solid, Liquid,

Abstract

Dual band Complementary Folded Arm (CFA) split ring resonator is designed to determine the dielectric properties of liquid and solid materials based on resonance frequency shifting. The structure resonator is light, small and low-cost and it operates at two resonant frequencies simulated by ANSYS HFSS-15 software. The advantages of this sensor are to identify the dielectric properties of two different samples for a solid sample at 2.5GHz and several common liquids at 3.9GHz. The results show the good performance of the shift of resonance frequency at the different dielectric values and achieve the high-quality factor compared with other RF sensors with 446 and 506 respectively. Due to this, the resonator can be a highly credible sensor for bio-sensing and food quality industry.

References

S. Trabelsi and S. O. Nelson, “Microwave Sensing of Quality Food Products,” IEEE Instrum. Meas. Mag., vol. 19, no. 1, pp. 36–41, 2016.

A. Rydosz, E. Brzozowska, S. Gorska, K. Wincza, A. Gamian, and S. Gruszczynski, “A Broadband Capacitive Sensing Method for LabelFree Bacterial LPS Detection,” Biosens. Bioelectron., vol. 75, pp. 328– 336, 2016.

A. A. Rammah, Z. Zakaria, E. Ruslan, and A. A. M. Isa, “Comparative Study of Materials Characterization using Microwave Resonators,” Aust. J. Basic Appl. Sci., vol. 9, no. 1, pp. 76–85, 2015.

P. M. Narayanan, “Microstrip transmission line method for broadband permittivity measurement of dielectric substrates,” IEEE Trans. Microw. Theory Tech., vol. 62, no. 11, pp. 2784–2790, 2014.

A. K. Jha, S. Member, M. J. Akhtar, and S. Member, “A Generalized Rectangular Cavity Approach for Determination of Complex Permittivity of Materials,” IEEE Trans. Instrum. Meas., pp. 1–10, 2014.

A. Foudazi and K. M. Donnell, “Effect of Sample Preparation on Microwave Material Characterization by Loaded Waveguide Technique,” IEEE Trans. Instrum. Meas., vol. 65, no. 7, pp. 1669– 1677, 2016.

P. Skocik and P. Neumann, “Measurement of Complex Permittivity in Free Space,” Procedia Eng., vol. 100, no. 4, pp. 100–104, 2015.

T. Reinecke, L. Hagemeier, S. Ahrens, M. Klintschar, and S. Zimmermann, “Permittivity Measurements for the Quantification of Edema in Human Brain Tissue – Open-ended coaxial and coplanar probes for fast tissue scanning,” 2014 IEEE Sensors, pp. 681–683, 2014.

C. Sen Lee and C. L. Yang, “Thickness and permittivity measurement in multi-layered dielectric structures using complementary split-ring resonators,” IEEE Sens. J., vol. 14, no. 3, pp. 695–700, 2014.

M. S. Boybay and O. M. Ramahi, “Material characterization using complementary split-ring resonators,” IEEE Trans. Instrum. Meas., vol. 61, no. 11, pp. 3039–3046, 2012.

A. A. Abduljabar, D. J. Rowe, A. Porch, and D. A. Barrow, “Novel Microwave Microfluidic Sensor Using a Microstrip Split-Ring Resonator,” IEEE Trans. Microw. Theory Tech., vol. 62, no. 3, pp. 679–688, 2014.

N. A. Rahman, Z. Zakaria, R. A. Rahim, and Y. Dasril, “Planar Microwave Sensors for Accurate Measurement of Material Characterization : A Review Refbacks,” TELKOMNIKA, vol. 62, no. 274, p. 564604, 2017.

L. M. Ledezma, “A Study on the Miniaturization of Microstrip Square Open Loop Resonators,” 2011.

A. V. V. Mannam and B. Y. R. Veeranki, “Design of Narrowband Band Pass Filter using Open-loop Square Resonators with Loading Element,” Indian J. Sci. Technol., vol. 9, no. December, pp. 1–9, 2016.

M. H. Zarifi, S. Farsinezhad, K. Shankar, M. Daneshmand, and S. Member, “Liquid Sensing Using Active Feedback Assisted Planar Microwave Resonator,” IEEE Microw. Wirel. Components Lett., vol. 25, no. 9, pp. 621–623, 2015.

W. Withayachumnankul, K. Jaruwongrungsee, A. Tuantranont, C. Fumeaux, and D. Abbott, “Metamaterial-based microfluidic sensor for dielectric characterization,” Sensors Actuators, A Phys., vol. 189, pp. 233–237, 2013.

M. T. Khan, M. A. Zakariya, M. N. M. Saad, Z. Baharudin, and M. Z. U. Rehman, “Analysis and Realization of Defected Ground Structure ( DGS ) on Bandpass Filter,” 5th Int. Conf. Intell. Adv. Syst., pp. 1–4, 2014.

M. K. Khandelwal, B. K. Kanaujia, and S. Kumar, “Defected Ground Structure : Fundamentals, Analysis, and Applications in Modern Wireless Trends,” Hindawi Int. J. Antennas Propag., vol. 2017, 2017.

I. M. at Rusni, A. Ismail, A. R. eda H. Alhawari, M. N. izar Hamidon, and N. A. zah Yusof, “An Aligned-Gap and Centered-Gap Rectangular Multiple Split Ring Resonator for dielectric sensing applications,” Sensors (Basel)., vol. 14, no. 7, pp. 13134–13148, 2014.

S. Kulkarni and M. S. Joshi, “Design and Analysis of Shielded Vertically Stacked Ring Resonator as Complex Permittivity Sensor for Petroleum Oils,” IEEE Trans. Microw. Theory Tech., vol. 63, no. 8, pp. 2411–2417, 2015.

C. Dalmay, J. Leroy, A. Pothier, and P. Blondy, “Development of high frequency microfluidic biosensors for intracellular analysis,” Procedia Eng., vol. 87, no. i, pp. 54–57, 2014.

M. A. H. Ansari, “Dual Band Microwave Sensor for Dielectric Characterization of Dispersive Materials,” Asia-Pacific Microw. Conf., vol. 1, pp. 1–3, 2015.

A. A. Mohd Bahar and Z. Zakaria, “Dielectric Analysis of Liquid Solvents Using Microwave Resonator Sensor for High Efficiency Measurement,” Microw. Opt. Technol. Lett., vol. 54, no. 12, pp. 2781– 2784, 2017.

A. Salim and S. Lim, “Complementary Split-Ring Resonator-Loaded Microfluidic Ethanol Chemical Sensor,” Sensors (Switzerland), vol. 16, no. 11, 2016.

M. T. Jilani, W. P. Wen, L. Y. Cheong, and M. Z. U. K. Rehman, “Determination of Size- Independent Effective Permittivity of An Overlay Material Using Microstrip Ring Resonator,” Microw. Opt. Technol. Lett. /, vol. Vol. 58, N, pp. 4–9, 2016.

S. P. Chakyar, S. K. Simon, C. Bindu, J. Andrews, and V. P. Joseph, “Complex permittivity measurement using metamaterial split ring resonators,” J. Appl. Phys., vol. 121, no. 5, 2017.

D. Pozar, Microwave Engineering Fourth Edition. John Wiley & Sons Ltd, 2005.

H. J. Lee et al., “A planar split-ring resonator-based microwave biosensor for label-free detection of biomolecules,” Sensors Actuators, B Chem., vol. 169, pp. 26–31, 2012.

M. A. H. Ansari, A. K. Jha, and M. J. Akhtar, “Design and Application of the CSRR-Based Planar Sensor for Noninvasive Measurement of Complex Permittivity,” IEEE Sens. J., vol. 15, no. 12, pp. 7181–7189, 2015.

I. M. Rusni, A. Ismail, A. R. Alhawary, M. N. Hamidon, and N. A. Yusof, “Aligned-Gap Multiple Split Ring Resonator for Dielectric Sensing Application,” Int. Conf. Eng. Technol. Technopreneush., pp. 143–147, 2014.

Downloads

Published

2018-07-05

How to Cite

Abd Rahman, N., Zakaria, Z., Abd Rahim, R., Dasril, Y., & Mohd Bahar, A. A. (2018). Dual Band Planar Microwave Sensor for Dielectric Characterization using Solid and Liquid Sample. Journal of Telecommunication, Electronic and Computer Engineering (JTEC), 10(2-8), 27–32. Retrieved from https://jtec.utem.edu.my/jtec/article/view/4452

Most read articles by the same author(s)