On Optimization of Manufacturing of an Enhanced Swing Differential Colpitts Oscillator Based on Heterostructures to Increase Density of their Elements: Influence of Miss-Match Induced Stress
Keywords:Analytical Approach for Modelling, Enhanced Swing Differential Colpitts Oscillator, Increasing of Density of Elements,
AbstractThis paper presents an analytical approach to model linear and nonlinear mass and heat transport with space and time varying parameters. The approach gives a possibility to predict mass and heat transport in multilayer structures without crosslinking the solution on interfaces between layers in these structures. Based on the approach, we analyzed the possibility to increase the density of field-effect heterotransistors in an enhanced swing differential Colpitts oscillator. The results indicate that the increase in the density of these transistors could be obtained by manufacturing them in a heterostructure with specific configuration using dopant diffusion or ion implantation with future optimized annealing. We also found that the fulfillment of specific detected conditions gives a possibility to decrease the mismatch-induced stress, which was generated in layers of the considered heterostructure.
Lachin, V.I., and Savelov, N.S. (2001). Electronics. Rostov-on-Don, Phoenix.
Polishscuk, A. (2004). Anadigm Programmable Analog ICs: All spectrum of analog electronics on a single chip. First meeting, Modern Electronics, Issue 12, 8-11.
Volovich, G. (2006). Modern chips UM3Ch class D manufactured by firm MPS, Modern electronics, Issue 2, 10-17.
Kerentsev, A. and Lanin, V. (2008). Constructive-technological features of MOSFET-transistors. Power electronics, Issue 1, 34-38.
Ageev, A.O., Belyaev, A.E., Boltovet, N.S., Ivanov, V.N., Konakova, R.V., Kudrik, Ya. Ya., Litvin, P.M., Milenin, V.V. and Sachenko, A.V. (2009). Au-TiBx-n-6H-SiC Schottky barrier diodes: the features of current flow in rectifying and nonrectifying contacts. Semiconductors, Vol. 43, 897-90.
Tsai, J.-H., Chiu, Sh.-Y., Lour, W.-Sh. and Guo, D.-F. (2009). Highperformance InGaP/GaAs pnp δ-doped heterojunction bipolar transistor. Semiconductors, Vol. 43, 939-942.
Alexandrov, O.V., Zakhar'in, A.O., Sobolev, N.A., Shek, E.I., Makoviychuk, M.M., and Parshin, E.O. (1998). Formation of donor centers upon annealing of dysprosium and holmium-implanted silicon. Semiconductors, Vol. 32, 921-923.
Ermolovich, I.B., Milenin, V.V., Red'ko, R.A. and Red'ko, S.M. (2009). Specific features of recombination processes in CdTe films produced in different temperature conditions of growth and subsequent annealing. Semiconductors, Vol. 43, 980-984.
Sinsermsuksakul, P., Hartman, K., Kim, S.B., Heo, J., Sun, L., Park, H.H., Chakraborty, R., Buonassisi, T. and Gordon R.G. (2013). Enhancing the efficiency of SnS solar cells via band-offset engineering with a zinc oxysulfide buffer layer. Appl. Phys. Lett., Vol. 102, 053901-053905.
Reynolds, J.G., Reynolds, C.L., Mohanta, Jr.A., Muth, J.F., Rowe, J.E., Everitt, H.O. and Aspnes, D.E. (2013). Shallow acceptor complexes in p-type ZnO. Appl. Phys. Lett., Vol. 102, 152114-152118.
Volokobinskaya, N.I., Komarov, I.N., Matioukhina, T.V., Rechetniko, V.I., Rush, A.A., Falina, I.V. and Yastrebov, A.S. (2001). Investigation of technological processes of manufacturing of the bipolar power highvoltage transistors with a grid of inclusions in the collector region. Semiconductors, Vol. 35, 1013-1017.
Pankratov, E.L. and Bulaeva, E.A. (2013). Doping of materials during manufacture p-n-junctions and bipolar transistors. Analytical approaches to model technological approaches and ways of optimization of distributions of dopants. Reviews in theoretical science, Vol. 1, 58-82.
Kukushkin, S.A., Osipov, A.V. and Romanychev, A.I. (2016). Epitaxial growth of zinc oxide by the method of atomic layer deposition on SiC/Si substrates. Physics of the solid state, Vol. 58, 1448-1452.
Trukhanov, E.M., Kolesnikov, A.V. and Loshkarev, I.D. (2015). "Long-range stresses generated by misfit dislocations in epitaxial films". Russian microelectronics, Vol. 44, 552-558.
Pankratov, E.L. and Bulaeva, E.A. (2015). On optimization of regimes of epitaxy from gas phase. some analytical approaches to model physical processes in reactors for epitaxy from gas phase during growth films. Reviews in theoretical science, Vol. 3, 365-398.
Ong, K.K., Pey, K.L., Lee, P.S., Wee, A.T.S., Wang, X.C. and Chong, Y.F. (2006). Dopant distribution in the recrystallization transient at the maximum melt depth induced by laser annealing. Appl. Phys. Lett., Vol. 89, 172111-172114.
Wang, H.T., Tan, L.S. and Chor, E.F. (2006). Pulsed laser annealing of Be-implanted GaN. J. Appl. Phys., Vol. 98, 094901-094905.
Bykov, Yu.V., Yeremeev, A.G., Zharova, N.A., Plotnikov, I.V., Rybakov, K.I., Drozdov, M.N., Drozdov, Yu.N. and Skupov, V.D. (2003). Diffusion processes in semiconductor structures during microwave annealing. Radiophysics and Quantum Electronics. Vol. 43, 836-843.
Zhang, Y.W. and Bower, A.F. (1999). Numerical simulation of island formation in a coherent strained epitaxial this film system. Journal of the mechanics and physics of solids, Vol. 47, 2273-2297.
Landau, L.D., and Lefshits, E.M. (2001). Theoretical physics (Theory of elasticity). Moscow, Physmatlit.
Gotra, Z.Yu. (1991). Technology of microelectronic devices. Moscow, Radio and communication.
Fahey, P.M., Griffin, P.B., Plummer, J.D. (1989). Point defects and dopent diffusion in silicon. Rev. Mod. Phys., Vol. 61, 289-388.
Vinetskiy, V.L., and Kholodar', G. A. (1979). Radiative physics of semiconductors. Kiev, Naukova Dumka.
Roy, A.G., Mayaram, K. and Fiez, T.S. (2015). Analysis and design optimization of enhanced swing CMOS LC oscillators based on a phasor based approach. Analog. Integr. Circ. Sig. Process., Vol. 82, 691-703.
Pankratov, E.L. and Bulaeva, E.A. (2014). An approach to manufacture of bipolar transistors in thin film structures. On the method of optimization. Int. J. Micro-Nano Scale Transp., Vol. 3, 17-31.
Sokolov, Yu.D. (1955). About the definition of dynamic forces in the mine lifting. Applied mechanics, Vol. 1, P. 23-35.
Pankratov, E.L. (2007). Dopant diffusion dynamics and optimal diffusion time as influenced by diffusion coefficient nonuniformity. Russian microelectronics, Vol. 36, 33-39.
Pankratov, E.L. and Bulaeva, E.A. (2017). On approach to increase integration rate of double-gate hete-rotransistors. Int. J. Nanoscience. Vol. 16, 1650039-1650054.
Pankratov, E.L. and Bulaeva, E.A. (2012). Decreasing of quantity of radiation defects in an implanted-junction rectifiers by using overlayers. Int. J. Micro-Nano Scale Transp., Vol. 3, 119-130.
Pankratov, E.L. (2011). Increasing of the sharpness of p-n-junctions by laser pulses. Nano, Vol. 6, 31-40.
Pankratov, E.L. and Bulaeva, E.A. (2016). Optimization of spatial dependence of diffusion coefficient for acceleration of dopant diffusion. Multidiscipline modeling in materials and structures, Vol. 12, 672-677.
Pankratov, E.L. and Bulaeva, E.A. (2017). On optimization of manufacturing of transistors in hybrid cascaded multilevel inverter to increase their density. Journal of computational and theoretical nanoscience, Vol. 14, 3548-3555.
How to Cite
TRANSFER OF COPYRIGHT AGREEMENT
The manuscript is herewith submitted for publication in the Journal of Telecommunication, Electronic and Computer Engineering (JTEC). It has not been published before, and it is not under consideration for publication in any other journals. It contains no material that is scandalous, obscene, libelous or otherwise contrary to law. When the manuscript is accepted for publication, I, as the author, hereby agree to transfer to JTEC, all rights including those pertaining to electronic forms and transmissions, under existing copyright laws, except for the following, which the author(s) specifically retain(s):
- All proprietary right other than copyright, such as patent rights
- The right to make further copies of all or part of the published article for my use in classroom teaching
- The right to reuse all or part of this manuscript in a compilation of my own works or in a textbook of which I am the author; and
- The right to make copies of the published work for internal distribution within the institution that employs me
I agree that copies made under these circumstances will continue to carry the copyright notice that appears in the original published work. I agree to inform my co-authors, if any, of the above terms. I certify that I have obtained written permission for the use of text, tables, and/or illustrations from any copyrighted source(s), and I agree to supply such written permission(s) to JTEC upon request.